300zx 90-96 2+0 Conv Na Manual 5speed Driveshaft Drive Shaft
I am selling my 2 piece 300zx drive shaft(stock shaft). The shaft is in perfect shape. The shaft is off of a 1996 nissan 300zx [108], Last Updated: Sat May 18, 2024
edw
Sun Jul 12, 2009
2 Comments
2400 Visits
I am selling my 2 piece 300zx drive shaft(stock shaft). The shaft is in perfect shape. The shaft is off of a 1996 nissan 300zx na convertible, with less than 100,000 miles. i selling because i upgraded my driveshaft with an 1 piece high performance aluminum and i dont need this one any more.
If you are not sure if it will fit your car, try measuring your shaft to see if its the same length
i used a tape measure and it comes close to 4ft
this is my 1996 z convertible i removed it from:
If you are not sure if it will fit your car, try measuring your shaft to see if its the same length
i used a tape measure and it comes close to 4ft
this is my 1996 z convertible i removed it from:
gz (United States)
Fri Jan 24, 2020
how long was your piece have you measured it ?
Joe
Sun Jul 31, 2011
I am intrested in your drive shaft are all the u-joints free and center bearing rubber support good. Joe